Yokogawa Data Acquisition with PID Control CX2000 Manual do Utilizador Página 1

IM CX1000-S35E Ed 01 Instruction Manual 1st Edition: April 2005 (YK) All Rights Reserved, Copyright © 2005, Yokogawa Electric Corporation

CO=20.9vol%TEMP ℃ 750 765 780 795 810 825 840 855 870 885 900 915 930 945 960 975 990 1005 1020 1035 1050%C ↓0.05 953 956 960 964 967 971 975 978 982

CO=22.0vol%TEMP ℃ 750 765 780 795 810 825 840 855 870 885 900 915 930 945 960 975 990 1005 1020 1035 1050%C ↓0.05 950 954 958 961 965 969 972 976 979

CO=23.0vol%TEMP ℃ 750 765 780 795 810 825 840 855 870 885 900 915 930 945 960 975 990 1005 1020 1035 1050%C ↓0.05 948 952 956 959 963 966 970 974 977

CO=23.5vol%TEMP ℃ 750 765 780 795 810 825 840 855 870 885 900 915 930 945 960 975 990 1005 1020 1035 1050%C ↓0.05 947 951 955 958 962 965 969 972 976

Contents Foreword...

IM CX1000-S33E 1Foreword Thank you for purchasing the CX1000/CX2000. This user’s manual describes an additional computation operators for carbon po

IM CX1000-S33E 22. CP Operator There are two CP computation operators to compute CP value (wt %) in furnace atmosphere for CX1000/CX2000-S35.

IM CX1000-S33E 33. CP Operator Setting Example A setting example of CP value control of loop 1 is as follows. - Press “MENU” key and press so

IM CX1000-S33E 44. Communication Command The followings are additional specification that related to CP operators. MT: Sets the control computa

IM CX1000-S33E 55.DAQSTANDARD PC Software The items that related to CP operators can be set beside the standard DAQSTADARD functions and special fu

IM CX1000-S33E 6CP operator setting in computation expression CP operators (_SC01, _SC02) are available in measurement/control computation. - Addi

IM CX1000-S33E 7Appendix 1 The specification relation between CX2000-S30 and CX1000/CX2000-S35 is described in below table. Relation