Yokogawa DAQWORX Manual do Utilizador descarregar pdf (Página 28)

IM WX1000-01E

Flow Chart of Connections and Operation

The ow of procedures described in this operation guide is shown below. This ow

assumes that all connections have been made.

Performing the Loop

Back Test, Read Test,

and Write Test*

Perform the test

execution**

Run GateCONTROL

as a process

Run GateWT as

a process

Logging data from the temperature

controller, WT210, MX100, or recorder

on DAQLOGGER

Logging and saving data

using AddMulti

See pages 31

and 32

See page 36

Set up the WT210

See page 29

See page 33

Set up GateCONTROL

Set up GateWT

See page 30 See page 35

Set up the MX100

See page 38

Executing GateMX/MW

See page 43

See page 32 See page 36

See page 44

See page 51

Check the communication

conditions of the recorder

• Ethernet (IP address

and host name)

• COM1-COM9

(address)

Set up the temperature

controller

* GateCONTROL Loop Back Test, Read Test, and Write Test

GateCONTROL allows you to perform loop back tests on any temperature

controllers connected to it.

If the loop back test results in anything other than OK, it may indicate a problem

in the wiring of the communication cable, or a mismatched baud rate, parity, or

Modbus address.

Also, by performing a test acquisition you can determine whether the data set for

each tag is correct.

** GateWT Test Execution

During GateWT’s test acquisition, data is read from WT output channels assigned

to each tag and displayed as digital values. This allows you to determine whether

the communication settings for each tag are correct.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 58 59

Comentários a estes Manuais

Sem comentários

Yokogawa DAQWORX Manual do Utilizador Página 28

Comentários a estes Manuais

Manuais e produtos relacionados com Software Yokogawa DAQWORX