Yokogawa ADMAG AXW Manual do Utilizador descarregar pdf (Página 16)

<3. INSTALLATION>

3-7

IM 01E25D11-01EN

5. Install the owtube into the customer’s pipe

with the gaskets A.

F0314.ai

Hang the grounding

ring up with this point.

Unfasten the bolts and

remove the grounding rings.

Cut out some holes on the

gasket B when necessary.

Wire

Grounding Ring

Flowtube

Screw & Nut : Connect the wire from the

grounding ring or the customer’s pipe.

Note : Gasket A and B should be placed concentrically with

the owtube.

Figure 3.3.6 Mounting Procedure with Grounding

Rings GR1 for sizes 1100 mm (44 in.)

and above

Mounting Procedure (with optional

Grounding Rings GR2):

The grounding rings are installed and locked

onto the owtube with gaskets B when shipped

from factory. Install the owtube into the

customer’s pipe with gaskets A supplied by

customer.

(5) Tightening Nuts

Pass the bolts from pipe line side, not owtube side,

and tighten the bolts according to the torque values

for the metal piping in Table 3.3.1 or 3.3.2

CAUTION

• Be sure to tighten the nuts according to the

prescribed toeque values. Tighten them

diagonally with the same torque values, step

by up to the prescribed torque value.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Sem comentários

Yokogawa ADMAG AXW Manual do Utilizador Página 16