Yokogawa DAQWORX Manual do Utilizador descarregar pdf (Página 51)

3-31

IM WX1-03E

Index

Detailed Description of Functions

3.3 Error Messages and Corrective Actions

Error

No. Message Corrective Actions

E211 Cannot write to file. Check if the disk capacity is sufficient or if the file systems is

normal.

E212 Cannot read file. Check if the file exists and is supported by the software or if the

file system is normal.

E213 Cannot open file. Check if the file exists and is supported by the software or if the

file system is normal

E401 Communication error. Check if the recorder connected for communication is powered on

and if the cable is properly connected. Also check the following

items according the the communication type.

• For Ethernet

Check if address settings are correct; the

TCP/IP

protocol is

installed in Windows; the Ethernet card is properly installed.

• For RS-232 and RS-422-A

Check if the baud rate settings match; the port (COM1 to COM9)

settings match, the address settings are correct (RS-422-A); the

serial port of the PC is active and the appropriate cable is being

used.

E402 Communication timeout. -

E403 Cannot open a communication port. Same as E401.

E501

Invalid license number.

Please reinstall the software.

Install the software again.

E1010 Execution of aprocess failed. Check whether an executable function exists, or whether its

files are damaged. If this error appears frequently, reinstall the

software.

E1011 Execuition of a service failed. Check whether an executable function exists, or whether its

files are damaged. If this error appears frequently, reinstall the

software.

E1600 The WT1000/WT2000 does not support With WT1000/WT2000 series instruments, model determination

can

Message

No. Message

M1201 Model determination was successful.

M1210 Setting changes saved before execution.

Executable Function Messages

No. Message Corrective Actions

W[631] Data Lack Reduce the number of acquired data points or connected

instruments, or lengthen the scan interval.

E[673] Cannot open communication Same as E401.

E[674] Communication error Same as E401.

E[675] Communication time out Same as E401.

E[850] Command Error An error was received from the WT. Check the status of the WT.

E[851] Cannot setting WT Check whether the communication status and connected

instruments matches those specified in the software. If they do

not, perform model determination again.

E[852] Recive Continued Check the communication status.

E[853] Recieve data error Check the communication status.

I[606] Recovery Communication Connection recovered.

1 2 ... 46 47 48 49 50 51 52

Comentários a estes Manuais

Sem comentários

Yokogawa DAQWORX Manual do Utilizador Página 51

Comentários a estes Manuais

Manuais e produtos relacionados com Software Yokogawa DAQWORX