Yokogawa DR240 Manual do Utilizador descarregar pdf (Página 98)

7-22

IM DR231-11E

Status output of hourly/daily/monthly report

The status of the hourly/daily/monthly report is output in the following format with the command,

TS4+device trigger(GET)+RF3.

Upper byte

Lower byte

If the newest hourly report data is valid this bit is 1,

if invalid it is 0

If the hourly report data is valid this bit is 1,

if invalid it is 0

If the newest monthly report data is valid this bit is 1,

if invalid it is 0

If the daily report data is valid this bit is 1,

if invalid it is 0

If the newest daily report data is valid this bit is 1,

if invalid it is 0

If the monthly report data is valid this bit is 1,

if invalid it is 0

Meaningless bit

Valid/invalid bit for the newest data

Using this bit, you can check which report, hourly, daily or monthly report, was created when the

internal timer of the status byte operated or when the bit which is generated at the time when the

report is created, is turned ON. The report which has the valid/invalid bit set to 1 is the one

created. For information on the status byte, refer to page 1-2 or 2-2.

Note

Valid/invalid bit for the newest data is reset one hour after the data becomes valid.

7.13 Report Output Format

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 120 121

Sem comentários

Yokogawa DR240 Manual do Utilizador Página 98