Yokogawa DAQWORX Manual do Utilizador descarregar pdf (Página 113)

5-17

IM WX104-01E

Configuring the DX100/DX200/MV100/MV200

Index

Scan Interval/Memory

Set these parameters when the data type is set to [EVENT & DISP] or [EVENT]

Click here (also selectable from [Setting] - [SETUP [Basic] Setting]-[Setting])

Check the channels you

wish to sample

A/D Integrate

100 ms can be selected only when the scan interval is set to 2 s.

Scan interval

The selectable scan intervals vary depending on the model as follows:

DX102, DX104, DX204, DX208, MV102, MV104, MV204, and MV208: 125 ms and 250

DX106, DX112, DX210, DX220, DX230, MV106, MV112, MV220, and MV230: 1s and 2 s

Memory Sample (save method of measured/computed data)

• Number of blocks

When the data type is [EVENT], select 1, 2, 4, 8, or 16.

When the data type is [EVENT&DISP], select 1, 2, or 4.

•

Pre-Trigger Length

If 0% is selected, the event le will entirely consist of data after the trigger. If 100% is

selected, the event le will entirely consist of data before the trigger.

• Memory Sample

Select the channels that are to be saved to the memory.

Note

If [Save] is set to [Manual], the data directory is created at a location that cannot be managed

by the DAQ Desktop. Therefore, the DAQ Desktop cannot be used to handle data files in that

directory.

5.5 Configuring the Setup Mode

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 335 336

Sem comentários

Yokogawa DAQWORX Manual do Utilizador Página 113