Yokogawa DAQWORX Manual do Utilizador descarregar pdf (Página 164)

6-37

IM WX104-01E

Index

Configuring the DX1000/DX2000

• Digit of lot number

Select the number of digits of the lot number from 4, 6, or 8. Select [OFF] to disable

the lot number.

• Auto increment

ON Automatically sets the lot number of the next measurement to “the lot number of

the current measurement + 1.”

• Trend Type

Function for the DX2000 only.

Settings Description

T-Y A trend display with a linear time axis

Circular A trend display with a circular time axis

• Partial

Turn Partial [ON] (partially expand) or [OFF] (do not partially expand).

• Trend Rate Switching

ON Enables the function that switches the trend interval while the memory sampling

is in progress. The “Second interval [/div]” item is displayed in the setting mode.

• When [Trend Rate Switching] is set to [ON], you cannot set [Data Kind] under

[Environment] - [Basic Environment] in the [Basic setting] tab to [E+D].

• This setting is fixed at [OFF] if you set [Batch operation qty] to [2] or higher on models

with the multi batch function (/BT2 option; release number 3 or later).

• Write Group

Settings Description

Common Write the message to all groups.

Separate Write the message to the displayed group.

• Power-Fail Message

ON A message is written when the DX recovers from a power failure while memory

sampling is in progress.

• Change Message

ON Writes the time the interval is switched and the new trend interval as a message

when the trend interval is switched.

• Scale over

Settings Description

Free The value is set to –over range if the value is less than –30000 and +over

range if the value is greater than 30000 excluding the decimal point. The

value is displayed as –Over and +Over, respectively.

Over The value is set to –over range if the value is less than –5% of the scale and

+over range if the value is greater than 105%. The value is displayed as –

Over and +Over, respectively.

Example:

If the scale is 0.0 to 200.0, the value is set to –over range if the value is less than

–10.0 of the scale and +over range if the value is greater than 210.0.

Note

For computations such as TLOG, CLOG, and report, the handling of the scale over-range value

can be set in advance.

• Alarm No Logging

Turn ON when using the Alarm No Logging function. The [Detect] setting is enabled in

the Measure channel/Math channel/Ext channel tab(s).

6.5 Entering Basic Settings

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 335 336

Comentários a estes Manuais

Sem comentários

Yokogawa DAQWORX Manual do Utilizador Página 164

Comentários a estes Manuais

Manuais e produtos relacionados com Software Yokogawa DAQWORX